问题如下：

我在rebulid all　过程中很成功．
Build Complete,
  0 Errors, 0 Warnings, 0 Remarks.

开始在load programe过程中发生
Data verification failed at address 0x0 ,please verify target memory and menmory map，
不光地址0x0,还有0x44 0x107
message框中还有
Loader: One or more sections of your program falls into a memory region that is
not writable.  These regions will not actually be written to the target.  Check
your　linker configuration and/or memory　map.
Warning: Too many H/W breakpoints. You cannot set more than one H/W breakpoint
per  processor bus. Sequence ID: 0 Error Code: 0 Error Class: 0x00000000.

我想问各位大哥　这是　我的XDSPCI没能正确识别出的原因么?
可是 我的CCS 的左下角已经显示 connected to target.
难道 xdspci 没识别出也可以 connected to target.??

解答如下：

英文的意思是说，程序被load到只读的内存区。你看看map文件和cmd文件，看看哪段程序被放到这个区域了？